Discussion in "Project Doubts" started by    gigyani    Apr 24, 2019.
Wed Apr 24 2019, 02:52 am
#1
How to enter the electronic voting machine into voting mode?
I have tried a lot but its not going to voting mode, it enters directly into result mode in which each candidate take equal amount of votes.
i have attached a photo of the project as it starts.
without this its doing nothing, so what could be the appropriate error?


[ Edited Wed Apr 24 2019, 02:53 am ]
Wed Apr 24 2019, 05:59 am
#2
http://www.8051projects.net/download-d205-electronic-voting-machine-managed-control-unit-project-report-included.html

At the end of the post the author adds a note about running cufirst.hex file in your controller.

Have you done that ?
Thu Apr 25 2019, 06:47 am
#3
when i add cufirst.hex its not working.
after 2-3 sec i add voting.hex again it goes to resulst mode

Get Social

Information

Powered by e107 Forum System

Downloads

Comments

Bobbyerilar
Thu Mar 28 2024, 08:08 am
pb58
Thu Mar 28 2024, 05:54 am
Clarazkafup
Thu Mar 28 2024, 02:24 am
Walterkic
Thu Mar 28 2024, 01:19 am
Davidusawn
Wed Mar 27 2024, 08:30 pm
Richardsop
Tue Mar 26 2024, 10:33 pm
Stevencog
Tue Mar 26 2024, 04:26 pm
Bernardwarge
Tue Mar 26 2024, 11:15 am