Discussion in "8051 Discussion Forum" started by    elt    Jan 7, 2020.
Tue Jan 07 2020, 07:06 PM
#1
So i have just began learning programming micros and decided an 8051 would be a good start. I have followed the instructions found here: https://github.com/rgwan/librech551/wiki/Setup-SDCC-developing-environment-with-Eclipse
My problems/questions are that it gives me an error "make: *** [stc.rel] Error -1073741515"
and tells me build failed, how do i fix this? Also where do i find the .hex file if it builds successfully? Sorry if i make stupid questions but i'm an complete noob.
Tue Jan 07 2020, 08:18 PM
#2
Not a stupid question.

Setting up "Eclipse" can be a nightmare, using "Make" can be a nightmare,
putting the two together is worse.
Eclipse is too complicated and you don't need its fancy features.

Download the free 8051 compiler from
http://www.keil.com/
It is used by most 8051 users.


[ Edited Tue Jan 07 2020, 08:23 PM ]
Sat Feb 01 2020, 02:20 PM
#3
If you want to use a CH55x MCU there isn't any advantage to use Eclipse as there is no support for debugging on CH55x.

I've followed the guide here with success: https://github.com/Blinkinlabs/ch554_sdcc

Get Social

Information

Powered by e107 Forum System

Conversation

Wed Jul 28 2021, 12:08 AM
Scrapernem
Scraper
Mon Jul 26 2021, 05:45 PM
GeorgeNer
InstagramPlus
Mon Jul 26 2021, 02:03 PM
Priscilla
Good write ups. Appreciate it! Https://bit.ly (https://bit.ly)
Mon Jul 26 2021, 01:48 PM
Lashawnda
Nicely put. Thanks. Dorthy (Dorthy)
Sun Jul 25 2021, 01:59 PM
xmmzdwpyfj
nvwmvcmsbi

Downloads

Comments

Mirza123
Thu Jun 25 2020, 03:46 PM
eunicelove124
Mon Jun 22 2020, 03:03 PM
cerouno
Tue Jun 16 2020, 05:10 PM
Marce
Sat Jun 13 2020, 09:43 PM
Davidthils
Thu May 21 2020, 12:44 PM
Jakeror
Thu May 21 2020, 01:28 AM
motorCar
Wed May 20 2020, 07:05 PM
Vordrync
Wed May 20 2020, 11:52 AM

Online

Guests: 62, Members: 0 ...

most ever online: 182184
(Members: , Guests: 182184) on 06 Aug 2010: 05:37 AM

Members: 38215
Newest member: Mirza123